INSPECTION & ACCEPTANCE
PREFORMED, PRE-COMPRESSED, SELF EXPANDING SEALANT SYSTEM
WITH SILICONE PRE-COATED SURFACE
Preformed, Pre-Compressed, Self-Expanding Sealant System with Silicone Pre-Coated Surface shall meet the requirements of Article 4136.
Acceptance of Preformed, Pre-Compressed, Self-Expanding Sealant System with Silicone Pre-Coated Surface will be based on approved sources. Approved joint fillers are listed in the Materials Approved Product Listing Enterprise (MAPLE).
To seek approved source status, the manufacturer shall submit to the Construction & Materials Bureau Laboratory in Ames, Iowa, a one-foot sample of finished material from regular production. The sample shall be accompanied by a report showing the quality control testing obtained by the manufacturer. The sample will be evaluated with results reported to the manufacturer. This status of source approval will be included with the report. The Manufacturer will notify the department of any changes to the products and re-submit quality control testing to verify continued compliance to specifications. Failure to notify changes to the department may remove the product from MAPLE.
The Office of Construction and Materials may sample a lot at the job site, supplier, or source and test to verify compliance with specifications.